Pneumatic Actuator

The pneumatic actuator P/N 980061 is used activate the “slave” nitrogen cylinders when two or more nitrogen cylinders are required. The actuator is mounted to the pressure differential valve on the nitrogen cylinder and activated by pneumatic pressure from the master cylinder.

FM Approved













NOTE: Before assembly or after system activation check to make sure that the tripping device (pin) had been re-set. See Section 6 ( Commissioning and Servicing) of the design, installation & Service manual for resetting instructions. Failure to assure the activating pin is in the non-activated position could cause system activation upon installing the pneumatic actuator.