Manual Actuator

The manual actuator P/N 980062 is installed on top of the solenoid actuator to provide an emergency manual release that is fully mechanical that can be used to activate the nitrogen cylinder by direct means case of failure to the normal electrical operation of the solenoid. Manual activation is accomplished by pulling the safety pin and pushing the lever handle in a downward motion.

FM Approved













NOTE: Before assembly or after activation, make sure the safety pin is installed and the tripping device (pin) has been reset. See Section 6 (Commissioning and Servicing) of the design, installation & Service manual for resetting instructions. Failure to assure the activating pin is in the non-activated position could cause system activation upon installing actuator.